Do You Remove Drip Edge Before Gutters

Asphalt roof shingles can become brittle in cold weather so wait until a warm but not hot day to remove and replace eave stripping.

Do you remove drip edge before gutters.

They are also known as d metal. If the overlap is too short fix it by placing drip edge under the first row of roof shingles and be sure that the exterior edge is reaching over the gutter. The only time you might not want to replace gutter flashing is when you don t want to remove decorative guttering that attaches with spikes or screws through the existing drip edge. When you install the drip edge over this strip it keeps the lower flange further from the home s siding which helps to keep water further from the home.

Although it is not the intention drip edge flashing will also provide protection for the fascia board. If this is the. Its main purpose is to eliminate the water from going behind the gutter. Drip edge is applied on the edge of the house roof to filter out all the water from the roof system.

Water stains dirt debris and dripping water behind a gutter are usually the result of poorly installed or missing drip edge. The drip edge further diverts it into the gutter. When it rains the water from the roof goes to the edge of the shingles and when the water backflows it hits the drip edge. Drip edge is an essential part of the roof system.

It directs all the water away from the fascia and then into the gutter. Because the drip edge directs the water directly down and into the gutters the back of the fascia is protected from excessive moisture. Most premade drip edge flashin. This helps to extend the life of the wood.

The drip edge is often replaced when new shingles are installed but it can be replaced at any time. If the gutter is lower than the bottom edge of the drip edge install flashing behind the drip edge and over the back edge of the gutter to remove the gap. A furring edge is a strip of one by two wood you install on the vertical surface of the house just beneath the roof s edge.