Door Sanding Service

This will roughen the surface a little and allow the primer to adhere better.

Door sanding service.

It may seem like a lot of work but it shouldn t take more than five minutes when the door is flat on the sawhorses. Once the full refinish service has returned your door to a good as new condition we can help you keep it that way and the maintenance service is designed for that purpose. Old wooden doors generally need sanding and priming. Apply one to two coats of penetrating stain wiping off any excess.

Start with a light sandpaper or a sanding sponge 180 or 220 grit. Start with a medium 120 grit piece of sandpaper and then work your way up to 220 grit paper. If the door still feels rough to the touch finish with a. Sand the door down to bare wood with 100 grit sandpaper.

After the finish has dried overnight gently hand sand it with 220 grit paper. Dust and sand with 280 grit paper then put on the final coat. Scotland door stripping is a well established company with more than ten years of experience in paint removing everything from doors to furniture. To get a smooth working surface scrape off any peeling pieces and sand down the old paint until the surface of the door feels even all over.

You don t want to sand through to bare wood dust the door and wipe it down with a tack cloth. It doesn t mean that you have to be an expert while using a door sander all that you need is the best suitable sander for doors which will make your demanding applications very easy. Fiberglass door refinishing slight different process than wood doors we use a special trip process process rather than sanding so we don t destroy the faux wood grain molding on fiberglass door also we use a special gel stain process and colors are somewhat limited in the gel stain selection however the final finish. This is usually the most time consuming tedious part of the project.

Sand with non clogging 180 or 220 grit sandpaper or sanding sponges look for non clogging or stearated on the label. Sand the dried primer lightly with 150 grit sandpaper to remove high spots and drips and to scuff the surface of the door. Sand the door again with 150 grit followed by 220 grit sandpaper. Brush on the second coat following the same order and let it dry overnight.

14 apply at least one finish coat of latex or oil based enamel paint to. This is needed for health and saftey reasons also prepares doors for sanding and any finish. Smooth out chipped paint and imperfections from previous paint jobs. Sand the door smooth.

Apply two or more coats of spar varnish allowing each coat to dry. For the smoothest possible topcoat hand sand the entire door after the primer and between coats of paint.